Apr 12, 2022 · Connecting the Polygon to a Net.

SOLVED: I restarted Altium Designer and everything is fine now.

.

I noticed that some of the vias look like the following, where blue is the GND polygon, and the GND net via does not connect to it at all. .

The lower portion of the Circuit Board Design follows the direct connect style.

.

It seems like the Polygon Plane needs to have the Net set and then Repour. The same is seen for thr +3v3 net (seen in yellow) where the via once again does not seem to connect to the polygon at all. exe.

.

Select the required net in the Connect to Net drop-down in the Properties panel. pcb-design. 13 and in Altium 16.

. All fanout vias and connecting track will be placed within the component's bounding rectangle.

.

All fanout vias and connecting track will be placed outside of the.

For Altium Designer to be able to perform a track to polygon conversion, the outline must be correctly defined. ; Name – specify a suitable name for the polygon.

For Altium Designer to be able to perform a track to polygon conversion, the outline must be correctly defined. The polygon pour will connect to each pad and via on this net that is found within the outline of the polygon, in accordance with the applicable Polygon Connect Style design rule.

.
altium.
Select the polygon and look to the properties panel.

.

All fanout vias and connecting track will be placed outside of the.

Layer – use the drop-down to select the layer on which the polygon is placed. The polygon pour will connect to each pad and via on this net that is found within the outline of the polygon, in accordance with the applicable Polygon Connect Style design rule. .

. . Polygon and track not connecting (both the same Net) Can't figure out how to connect the polygon and track (both the same Net) seen in the provided screenshot. In Only - fanout in an inward direction only. Once open, go to the left side of the menu and select “PCB Editor > Defaults”. In Only - fanout in an inward direction only.

In Only - fanout in an inward direction only.

Available checks are listed in the grid area of. The polygon pour will connect to each pad and via on this net that is found within the outline of the polygon, in accordance with the applicable Polygon Connect Style design rule.

For this instance, it looks like the polygon's minimum neck setting is preventing the polygon from reaching that pad.

It connects as expected to all the other pads, it’s just this footprint giving me issues.

Available checks are listed in the grid area of the Checks region on the Health Checks tab.

.

Select the polygon and look to the properties panel.